EMS XtremeRGB-Ex1 Manuel d'utilisateur

10 Nov 2009 Electronic Modular Solutions Limited Kendal House, 20 Blaby Road, S. Wigston, Leics., LE18 4SB, England Tel: +44 (0) 116 2775730 Fax: +

Installing the Capture Card You are likely to need a flat blade and a Phillips head screwdriver for the installation of the capture card; it would be

Installing Multiple Cards Up to 32 cards can be installed in a system providing a maximum of 32 capture channels. Combinations of all XtremeRGB captur

Firmware Upgrades The XtremeRGB-Ex1 cards allow firmware upgrade to be completed on site rather than returning the card to EMS. Whenever a firmware

• Ability to set up sources accurately (settings automatically saved) • Save a single frame to a file in one of the following formats: BMP, JPEG, G

Chapter 4 XtremeRGB-Ex2 FCC Compliance – XtremeRGB-Ex2 Federal Communications Commission Statement This device complies with FCC Rules Part 15. Oper

DECLARATION OF CONFORMITY Per FCC Part 2 Section 2. 1077(a) Responsible Party Name: EMS Limited Address: Leicester, England Phone: +44116-2775730

Introduction – XtremeRGB-Ex2 The XtremeRGB-Ex2, a dual channel PCIe capture card can capture: • Component HD up to 1080P at 60 frames per second (Re

Specification • Board Format PCIe half size plug-incard card, 110mm x 170mm PCIe bus master with scatter gather DMA providing maximum data rate of 4

• Separate Sync Polarity: Positive or Negative. (Separate H & V sync, Composite Sync) • Sync On Green Polarity: Negative • Inputs: 75 Ohm termina

Connections The XtremeRGB-Ex2 card has two DVI-I type connectors for two separate, simultaneous inputs. The top connector is referred to as Channel 1

Contents Chapter 1 Safety Instructions ...

To run the dplinks program open the Run by clicking on Start/Run and type dplinks and then press Enter. The program will run, however no notifications

Application Overview The application displays the analog RGB / DVI source in a window; it has the following features: • Scales the analog RGB / DVI d

Chapter 5 XtremeRGB-II FCC Compliance Federal Communications Commission Statement This device complies with FCC Rules Part 15. Operation is subject

DECLARATION OF CONFORMITY Per FCC Part 2 Section 2. 1077(a) Responsible Party Name: EMS Limited Address: Leicester, England Phone: +44116-277573

Introduction The XtremeRGB-II, a dual channel PCI-X capture card can capture: • Component HD up to 1080P at 60 frames per second (Requires optional

Specification • Board Format 64 bit, up to 66MHz PCI-X, half size plug-in card 105mm x 170mm. PCI bus master with scatter gather DMA providing maxim

• Vsync: No hardware limits, typically 25Hz - 200Hz for real signals • Separate Sync Polarity: Positive or Negative. (Separate H & V sync, Composi

Installing the Capture Card You are likely to need a flat blade and a Phillips head screwdriver for the installation of the capture card; it would be

Installing Multiple Cards Up to 32 cards can be installed in a system providing a maximum of 64 capture channels using the XtremeRGB-II. Combinations

Firmware Upgrades The XtremeRGB-II card allow firmware upgrades to be completed on site rather than returning the card to EMS. Whenever a firmware

Chapter 1 Safety Instructions To prevent damage to your EMS product or injury to personnel operating the equipment, please read the following safet

Software Installation The XtremeRGB software (driver and application) is installed by inserting the CD that was shipped with your card into your CD RO

Using the card with other EMS products The XtremeRGB-II captures the HD/HDMI/ RGB/DVI data and stores it in an on-board video buffer. This data is t

Chapter 6 XtremeRGB-Ex8 FCC Compliance Federal Communications Commission Statement This device complies with FCC Rules Part 15. Operation is subject

DECLARATION OF CONFORMITY Per FCC Part 2 Section 2. 1077(a) Responsible Party Name: EMS Limited Address: Leicester, England, Phone: +44116-277573

Introduction – XtremeRGB-Ex8 The XtremeRGB-Ex8 is an eight channel PCI express video capture card. The card supports PAL, NTSC and SECAM in both compo

Specification • Card Format : 4 lane PCI express 110x170mm (approx) • Connectors: Two 26 Way D Connectors • Maximum Capture Resolution: 8x 720x576x

Installing the XtremeRGB-Ex8 Capture Card You are likely to need a flat blade and a Phillips head screwdriver for the installation of the capture card

Video Input Termination Links 1 J2+J6 2 J7+J9 3 J12+J13 4 J10+J11 5 J14+J17 6 J15+J16 7 J18+J21 8 J19+J20 Installing Multiple Cards Up to 16 cards

Firmware Upgrades The XtremeRGB-Ex8 card allow firmware upgrade to be completed on site rather than returning the card to EMS. Whenever a firmware u

The supplied drivers and software require that you are using: • Windows® XP PRO/Server 2003/Server 2008, Windows®Vista or Windows® 7 • CD / DVD ROM

Chapter 2 Introduction The EMS XtremeRGB range of video capture cards HD, HDMI, VGA/ RGB or DVI video sources in real time enabling you to view dat

Chapter 7 XtremeRGB-Ex4+ FCC Compliance Federal Communications Commission Statement This device complies with FCC Rules Part 15. Operation is subjec

DECLARATION OF CONFORMITY Per FCC Part 2 Section 2. 1077(a) Responsible Party Name: EMS Limited Address: Leicester, England, Phone: +44116-277573

Introduction – XtremeRGB-Ex4+ The XtremeRGB-Ex4+ is an ideal solution for applications that require the capture of up to four SD video sources and a

Models XtremeRGB-Ex4+

Specification • Board Format: PCI-e x4 plug-in card, 110mm x 204mm PCI-e bus master with scatter gather DMA providing maximum data rate of 480MB/s •

Unpacking Your packing box should contain the following items: • XtremeRGB-Ex4+ • BNC16 Input Cable • DVI-VGA Adapter • Installation CD ROM If the

Installing the XtremeRGB-Ex4+ Capture Card You are likely to need a flat blade and a Phillips head screwdriver for the installation of the capture ca

D-Type Connector Connect SD inputs using the 16-way splitter cable (provided). The splitter cable consists of 16 BNC sockets numbered 1-16, connecte

Installing Multiple Cards Up to 8 cards can be installed in a system providing a maximum of 32 SD capture channels and 8 DVI-I capture channels. In

Firmware Upgrades The XtremeRGB-Ex4+ card allows firmware upgrades to be completed on site rather than returning the card to EMS. Whenever a firmwa

Chapter 3 XtremeRGB-Ex1 FCC Compliance XtremeRGB-Ex1 Federal Communications Commission Statement This device complies with FCC Rules Part 15. Operat

Application Overview The application displays the video source in a window; it has the following features: • Scales the video data to fit in the win

Chapter 8 EMS Limited EMS has a long and very successful history in the computer graphics industry. EMS has been designing and supplying high per

UK Headquarters and Main Sales Office Electronic Modular Solutions Limited Kendal House, 20 Blaby Road S. Wigston, Leics., LE18 4SB, England Tel: +4

Chapter 9 Index BMP, 13, 21, 30, 38, 49 Board Format, 25, 35, 43 Channel 1, 19, 27 Channel 2, 19, 27 Connectors, 25, 35, 43 EMS, 50 DMA, 13, 21, 3

Video Capture Memory, 8, 17, 25, 35, 43 Video Format, 8, 17, 25, 43 Video Sampling, 8, 17, 25, 43 XtremeRGB-Ex4+, 49

DECLARATION OF CONFORMITY Per FCC Part 2 Section 2. 1077(a) Responsible Party Name: EMS Limited Address: Leicester, England Phone: +44116-277573

Introduction – XtremeRGB-Ex1 The XtremeRGB-Ex1 a single channel PCIe capture card can capture: • Component HD up to 1080P at 60 frames per second (R

Specification • Board Format PCIe x4 low profile card, 68.9mm x 167.6mm PCIe bus master with scatter gather DMA providing maximum data rate of 480M

• Separate Sync Polarity: Positive or Negative. (Separate H & V sync, Composite Sync) • Sync On Green Polarity: Negative • Inputs: 75 Ohm termina